Eylar® SA00001 Standard Waterproof and Shockproof Gear Hard Case with Foam Insert

The Green Eylar SA00001 Standard Waterproof and Shockproof Gear Hard Case with Foam Insert is designed to secure your gear for transport or storage. A crushproof, folding carry handle makes this case easy to transport or store inside of a backpack or other small bag. The equipment case is injection-molded from reinforced, high-pressure polypropylene plastic that is waterproof and crushproof. Its adaptive pressure-equalization valve releases built-up air pressure allowing for atmospheric compensation when transported at high or low altitudes and within cargo vacuums. A waterproof seal is formed when the case is latched closed, applying pressure to a rubber gasket that is molded to the perimeter of the case. When fully submerged, it provides waterproof protection for up to 3.2 ft. (1 m). The gear case is also resistant to extreme heat and freezing cold with a working temperature range of -20°F (-29°C) to 140°F (60°C). The SA00001 hard equipment case comes with 3 layers of foam designed to keep your valuables firmly in place — 2 fully customizable pull-and-pluck cubed foam layers and 1 layer of egg-crate foam padding for the lid. 2 press-and-pull snap latches secure the full length of the case. 2 padlock-adaptable fittings allow for secure storage at home or on the go. Uniform ridges on the top and bottom create an in-line stackable design for multi-case transport. The outer dimensions are 13.37 in. x 11.62 in. x 6 in. while the inner storage area is 11.81 in. x 8.87 in. x 5.18 in._