Impresa [2 Pack] Steel Blade for Fiskars Replacement PowerGear Bypass Lopper 25" & 31" and PowerGear 2 Bypass Lopper 27" & 32"

Cut through the Clutter Refresh your pair of long loppers with these Impresa large blades for Fiskars lopping tools PowerGear Bypass Lopper 25" & 31" and for PowerGear 2 Bypass Lopper 27". Slice through branches like butter with Impresa hedge lopper blades for Fiskars replacement parts capable of cutting branches up to 2" thick. Made from high carbon steel and coated with PTFE to reduce friction, the Impresa blades for Fiskar replacement parts offer smooth cuts and rust resistance. Add this set of 2 blades to your collection of loppers parts and always have one on hand during the pruning season. Instructions: - While wearing suitable safety gear, remove both 1/2" bolts using a wrench with a 1/2" socket or a 1/2" combination wrench. Do not lose washers or nuts when removing the anvil lopper blade. - Remove the old garden loppers blade and position the replacement. Reconnect the blade one bolt at a time. - Reattach one bolt at a time. Position each so it connects the hand loppers to the blade. Add the original washer and nut. - Tighten the nut until the head of the bolt begins to spin. Use pliers to hold the head of the bolt static to finish tightening. - Do not over-tighten the bolt! The gardening loppers still need to pivot smoothly. Loosen nuts slightly if lopping shears don't open and close easily. - Repeat the process for the second bolt. For correct alignment, attach the new blade with the anvil loppers completely closed. - Test to make sure the loppers for gardening open and close easily. Make any necessary adjustments. Note: This is an aftermarket product manufactured by Impresa. Any other brands mentioned are for illustrative purposes only and are in no way affiliated with Impresa, nor do they endorse Impresa.